Honda Africa Twin Fork Mount

Visionx Billet Tube Clamps (Pair) Fits 2.25" tubing. XIL-C225. I had these left over from another motorcycle. I'm going to use these temporarily until my crash bars come in. Then I'm going to mount the lights on the crash bars.

Visionx Clamps Visionx Billet Tube Clamps (Pair) Fits 2.25" tubing. XIL-C225. I had these left over from another motorcycle. I'm going to use these temporarily until my crash bars come in. Then I'm going to mount the lights on the crash bars.

Mounting the Light Pods I'm going to mount these on the 55mm Honda fork tubes until my crash bars get delivered.

Make sure the fluted lenses will end up vertical and on the bottom when they are finally mounted. I had to move these down till they were 1-3/4" under the tripple tree because the lights were running into the fairing when I turned the wheel lock to lock.

Mounting the Light Pods Make sure the fluted lenses will end up vertical and on the bottom when they are finally mounted. I had to move these down till they were 1-3/4" under the tripple tree because the lights were running into the fairing when I turned the wheel lock to lock.

I used masking tape as a marker for the position of the mount. The fork tubes are a little smaller than the clamps so I put a strip of thin rubber between the clamp and the fork. Before I put the lights on the clamps I put a 24" level across the front surfaces to make sure they are parallel.

Mounting the Light Pods I used masking tape as a marker for the position of the mount. The fork tubes are a little smaller than the clamps so I put a strip of thin rubber between the clamp and the fork. Before I put the lights on the clamps I put a 24" level across the front surfaces to make sure they are parallel.

Make sure the lights are pointing slightly down. They will have to be aligned later. Route the wires to the harness and tie them up with cable ties.

Mounting the Light Pods Make sure the lights are pointing slightly down. They will have to be aligned later. Route the wires to the harness and tie them up with cable ties.

The Lights Work