OEM Risers The bike fell over on its right side in the garage. The handlebars were jacked to the right. I took this apart to make sure the OEM risers weren't bent. The OEM caps have 10mm screws.
OEM Risers 3" risers with a stud in the center. The nut that fastenes the riser to the upper tripple tree is 17mm and gets torqued to 39nm / 29ft/lbs.
OEM Risers 3" risers with a stud in the center. These risers are very stout. The riser nut is 17mm and gets torqued to 39nm / 29ft/lbs.
OEM Risers The rubber washer faces down and sits on the top surface of the tripple tree. This gives the risers some flexibility so they don't bend.
OEM Risers 3" risers with a stud in the center. The riser nut is 17mm and gets torqued to 39nm / 29ft/lbs.
OEM Risers After a fall checking if the stud is bent. The studs weren't bent. I put the whole thing together and it straightened out about 1/2 the problem. I took the front wheel and wedged it between 2 objects in the garage and torqued the bars over to the left which straighted it all out perfectly.
